Each of the outputs can be switched off so that non critical loads can be removed to enable the battery to support the critical loads. The rectifier and controller modules can be hot swapped without supply AC or DC supply interruptions.

Connection Module (Option /MBATT500)

The connection module permits an electronically controlled distribution via three DC outputs. Each output is electronically overcurrent protected. The tripping current is adjusted via the software. After tripping, the output can be reset manually by means of a push button. Alternatively, a reset is also possible via the management system. All outputs can be switched individually. 

To save battery capacity, certain outputs can be switched off, such as by means of a time-control command or triggered by a power supply failure. In this case, the shutdown can take place immediately or with a certain delay. The device has an integrated impedance bridging for the connection of 12V or 24V batteries. The battery connection is made possible by the controller item PI-CRT2004 and can be parameterised via the operating software.

The controller module is used for controlling and monitoring the REC500-230-48-K9 system via the internal CAN bus. The Local Craft Terminal (LCT) LAN interface permits the connection of a local PC or network. A clear and easy-to-operate user interface facilities control, programming and linkage of all controller parameters depending on user requirement.

If your test requirement is short term, we have a wide range of DC sources in our rental range.